Directions

Dilution Rate: Mix 1 part 77 XXX with 25 parts water for removal of heavy soil or road film without brushing. Mix 1 part 77 XXX with up to 100 parts water for light cleaning or to use with brushing. Temperature: 77 XXX will remove soil at low temperatures; however, higher temperatures will greatly improve performance.

Pressure: Apply 77 XXX to surfaces with high or low pressure. High pressure will enhance product performance.

For Best Results apply at high temperatures (140°- 1600F) and high pressure (above 600 psi), to a dry surface. Always rinse with high-pressure water.

1. Apply dilutions to surface to be cleaned, working from bottom to top to avoid streaking. 77 XXX may be applied to as large a surface area as desired, being careful not to allow 77 XXX to dry on surface. (For example, apply to one side of a trailer.)

2. Rinse thoroughly with high-pressure water, working from top to bottom.

3. Hold pressure nozzle 12″ from vehicle surface. AUTOMATIC CAR WASHES

Prep Gun: Mix 1 part with 128 parts water. Apply to dry vehicle, allowing a maximum of 15 to 20 seconds before detergent application.

Touchless & Hybrid Systems: Mix 1 part with 128 parts water. Apply to vehicle through high-pressure spray equipment. Follow immediately with acidic detergent.

Wheel Wash: Mix 1 part with 25 parts water. Apply to dry wheels (tires). Allow 10 to 20 seconds contact time, agitate as necessary, then rinse thoroughly with a strong stream of water. Rinse immediately from painted surfaces to eliminate possible discoloration. Not recommended for polished aluminum or magnesium wheels as streaking or dulling may occur. NOTE: Test on an inconspicuous area when using on a surface for the first time. DO NOT allow overspray to dry on glass surfaces.

RECOMMENDED USES

NON-PHOSPHATE

Works with light or low pressure.

Economical – saves time and labor.

Environmentally desirable – Contains no phosphates, caustics, acids or solvents.

BIODEGRADABLE: All detergents used in the manufacture of this product are biodegradable.

This product is designed exclusively for industrial and institutional use by trained, professional maintenance personnel. Label directions and precautions must be followed exactly. Manufacturer and distributor will not be responsible for any injury, loss, or damage if product is used in any manner not in compliance with label directions, or if precautions are not observed. Immediately rinse to prevent formation of stubborn residue. DO NOT use in self­ service or manual car wash applications.

NET CONTENTS

55 Gallons

CAUTION

EYE AND SKIN IRRITANT.

KEEP OUT OF REACH OF CHILDREN.

SEE SIDE PANEL FOR ADDITIONAL

PRECAUTIONS AND FIRST AID.

Contains sodium metasilicate. CAUSES EYE IRRITATION. May cause skin irritation or inflammation. Inhalation of spray mists or vapors may cause respiratory tract irritation. DO NOT breathe vapors or spray mist. DO NOT swallow this product. Repeated exposure can have cumulative effects. Further information on the effects of overexposure is included on the Material Safety Data Sheet, which is available upon request. Limit exposure to all chemical products. Wear tight fitting, splash-proof safety goggles during product use, especially contact lens wearers. Wear natural rubber, nitrite. neoprene, or other resistant gloves. Use product in well-ventilated areas only; open window/doors and use exhaust fans in enclosed areas. Remove contaminated clothing promptly and DO NOT re-wear until thoroughly cleaned. After handling, wash hands thoroughly with soap and water.

FIRST AID:

EYES: Immediately flush eyes with plenty of water for at least 15 minutes, occasionally lifting the upper and lower eyelids. Get medical attention immediately. SKIN: Immediately flush contaminated skin with plenty of water for at least 15 minutes. Get medical attention if irritation develops. INHALATION: Move exposed person to fresh air. If irritation persists, get medical attention immediately. INGESTION: If this product is swallowed, DO NOT induce vomiting. If vomiting occurs keep head below hip level to prevent aspiration (breathing) of fluid into the lungs. If affected person is conscious, give plenty of water to drink. Get medical attention at once.

DISPOSAL AND/OR SPILL INFORMATION: As with all cleaning and maintenance procedures, run-off from the cleaning or maintenance process should be diverted to a collection vessel, or where permitted, to a sanitary sewer (consult local and state regulations) and not allowed to soak into the ground or to enter a storm sewer. If this product is spilled or contaminated and cannot be used, creating the need for disposal, absorb product on an inert absorbent material, and deposit in a clean, sealable D.O.T. specification container for disposal as a hazardous waste. Rinse area well with water. STORAGE: Store tightly closed container in dry area at temperatures between 40°F (4’C) and 120°F (49°C). DO NOT store at temperatures below 32°F (0°C). Keep this product away from food and food products.